(based on 55 reviews)
of respondents would recommend this to a friend.
Reviewed by 55 customers
Displaying reviews 1-10
Back to top
Previous | Next »
Didn't have instructions on how to use the product.
from Murphy, NC.
Comments about Ring Sizers Set of 4:
I say again, needed instructions on how to use the product. Would have been helpful.
Bottom Line Yes, I would recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
Difficult to put on & didn't fit soldered ring
from Minneapolis, MN
I wanted this size adjuster for my engagement and wedding rings which are soldered together, but the tabs were not long enough to wrap around the two bands. I then tried using one of them on a single-band ring and it was very difficult to hold it in place while bending the tabs (which required pliers). I make jewelry as a hobby so I'm accustomed to working with small pieces, yet I really struggled with this. It was comfortable once I got it on, though.
Bottom Line No, I would not recommend this to a friend
from Victoria B.C. Canada
About Me Career, Practical
a wonderful solution for short or long term finger size change. goes on well, and saves many dollars of repair. Lasts well, only takes a few days to get used to it. great if concerned about theft in hospital or surgery. I use both wide and narrow ones. easily put on and removed.
(0 of 1 customers found this review helpful)
I would never buy this item again!
from Eureka, CA
About Me Classic, Practical, Stylish
Things not great about this product: everything!
did not work on my rings
from Boalsburg, PA
About Me Comfort-Oriented, Modern
I ordered the largest size and it still did not fit my wedding band and 2 other rings. The rings were only size 7 and 8 they should of fit. Would not order again.
Waste of money.
About Me Practical
(1 of 1 customers found this review helpful)
Sorry--but do not work.
from Willow Grove, PA
About Me Classic, Comfort-Oriented, Practical
I have been spending a lot of money lately trying to get ring sizers for my Mom's great-grandchildren's birthstone ring. I was hoping these would work, but they do not work. I tried to get it on, but then, it just slides off the ring. I think the end tips are too short. Her ring was not expensive, so I really do not want to have it professionally resized--even though it is an important ring for her. Sorry. Marianne
from Ennis, TX
I sent to a thire party addess. I assumed it was received. But at Christmas, it had not been received.
from Dayton Ohio
piece of junk
Must be me
from Williamsburg, VA
About Me Comfort-Oriented, Practical, Stylish
I just couldn't get these to work, as they kept slipping out of the ring.